Caring RV fresh water to a system need not be a daunting process. Indeed, it is easier than most people think. There is no guarantee that any system provides completely safe water or pure water, but can take some precautions to keep your RV water safer and easier to use. Thanks to Mark Polk on his contributions.
Begin with a white, non-toxic drinking hose. Hoses not labeled " safe to drink " can allow lead and other dangerous chemicals to enter the water. Use the white non-toxic hose only for hooking up to its water source. Take the green or black garden hose for all flushing and filling other tasks, such as cleaning or washing of the RV holding tanks. While drinking white hose is not in use, roll it and connect the two ends together. This will keep the dirt, contamination and other debris to stay in the hose. When you are ready to use it again, do some clean water through the hose as an added precaution before hooking it to the RV.
The next step is to filter the incoming water with a filtration system of high quality. Water filters can not purify the water completely, but they can help control and eliminate bacteria, lead and other dangerous contaminants found in drinking water. Hydrolife filter characteristic of a filter media called KDF which uses electrochemical oxidation-reduction to neutralize harmful substances and bacteria. Hydrolife also uses carbon filter to reduce pesticides, fungicides and other organic contaminants.
There are two basic options to filter their RV water system. A filter inline installs directly to the water they drink line. The other, it is more preferable option to filter all the water goes to the RV. By doing this, you are protecting the entire water system, filtering the shower water to help prevent any skin irritation.
Possibly the most important step is to keep your system freshwater sanitized. In an absolute minimum, the system should be sanitized every spring when you take the RV out of storage. Also, be sure to sanitize the system of freshwater any time you notice a odor.
To sanitize the system of freshwater, begin by emptying the water heater. Find the water heater in the compartment outside their RV. The escape of fit, or petcock, located at the lower left. Pull the plug and open the pressure relief valve on top of the water heater. CAUTION: NEVER drain the water heater when the water is hot or the tank is under pressure.
Locate the lowest point where the water drain lines. Look carefully, as they can be hard to find. There will be one for hot and one for cold water lines. This is the lowest point in the water system. Open them and let the water drain out. Then, locate the drain into the reservoir of fresh water holding and releasing all the water from it. At this point, turn the water pump at a time to force any remaining water. Be sure to turn off the pump, and the water stops draining. Close all sinkers. Most of the water has been drained from the next step in system.
The sanitizing its water system is taking quarter cup of household bleach for every fifteen gallons of water that the reservoir of fresh water holds. Mix the bleach with water in a container of a gallon and pour it into the holding tank of fresh water. Then fill the tank of fresh water almost completely filled with water. Turn the pump d & 39; water, open all hot and cold taps in their RV and run the water until the bleach smell in each tap. Close the taps. If it is possible, pull the trailer or lead to RV to move the water around and help in the cleaning of the entire tank.
Once the tank was filled with a bleach mixture of water, let it sit for at least 12 hours. Drenar whole system again, and then back to fill the tank of fresh water with drinking water. Open all the faucets and run the water until you can no longer smell any bleach. You may need to repeat this process to remove all signs of bleach from the system of water. When the smell of bleach is gone, it is safe to use their water system.
Modern RVs are equipped with automatic pressure pumps demand, polyethylene tanks for storage of fresh water and water polybutylene lines. These systems are designed to operate at a certain level maximum pressure of the water, about 35 to 45 pounds per square inch. The pump board has a built-in pressure switch that turns off the power to pressure of the pump when it was reached. Most homes and RV parks in the city have a connection to supply water water. Often, the pressure on these facilities more than 80 pounds per square inch, and sometimes more.
Take very careful, as this high pressure can and will cause leaks, develop.
For his peace of mind, investing in a simple pressure of water for use regulatory Whenever you are using a source of water outside. This device controls the next water supply for a continuous pressure and regulated 45 PSI maximum. The regulator is connected to the supply end of the hose to protect hoses and RV at the same time. You can buy a pressure regulator of the water supply in your local RV store.
People enjoy the RV life because it offers freedom to travel with all the comforts of home. Make sure your comfort include a supply of drinking water, where your travels may take you. nanci indy
Bookmark it:
No comments:
Post a Comment